Disclaimers
Warning Disclaimer
Technical rock climbing is inherently dangerous. Our products are for rock climbing, bouldering. Any person using our gear in any manner is personally responsible for learning the proper techniques and good judgment. We strongly recommend that every climber seek instruction by a qualified professional. You are responsible for knowing and respecting our products capabilities and limitations. Always know the maintenance and use history of your equipment and destroy retired gear to prevent future use. The use of secondhand equipment is strongly discouraged. You are responsible for your own actions and decisions. Failure to follow these warnings can result in severe injury or death.
Make sure you have read all information that is accompanied by the weclimbstronger product(s) when purchased and you have reviewed the weclimbstronger website before use.
Make sure you understand how weclimbstronger product(s) are intended to be used and any limitations on its use.
Certain components are sourced from 3rd party suppliers which we have determined to be adequately reputable. While these suppliers do provide load ratings for these components we cannot guarantee their accuracy or reliability.
Product Disclosures
Our products are manufactured via 3D printing, which is an additive manufacturing process. This allows us to keep cost down and also allows for rapid product refinements and improvements. Due to this nature of manufacturing, we can resolve flaws or add improvements to our products without expensive molds or tools. This may result in slight variations of our products from time to time.
With 3D printing, there are notable features in our products. First and foremost is layer lines, these are the results of the printing process where the product is build up layer by layer on a 3D printer. Depending on the product's orientation on the 3D printer's build plate, some surface may exhibit less of these layer lines.
Occasionally, small strands or whisps of filament and bumps may remain on our products. These are usually easily removed by using a nail clipper and carefully clipping them off or simply left alone. On the occasion that an exposed strand, do not pull on it may dislodge the surrounding layers. Simply use a nail clipper and clip off the strand at both ends carefully.
Limitations
We strive to design our 3D printed parts to be as strong, safe and durable as possible.
Our products are not rated nor build for dynamic loads.
We have load tested each product to determine its safe working range. We advise using common sense when applying loads that approach the recommended limit as materials may fatigue over time and break should it be overloaded.
Do not subject our products to excessive heat(greater than 50°C) for any amount of time, sunlight or impact from dropping or being struck by a heavy object such as weights, its structural integrity may be compromised without any visible signs.
If the products shows any sign of damage or deformation it should not be used.
Our products are designed for training purposes only. They should never be used for climbing or at height.
Occasionally we may need to source materials from different suppliers depending on demand and availability. While we try to maintain consistency and coherency, we cannot guarantee that the colours you see on your screen will match the colour of the products you receive.
If you have any concerns, complaints or suggestions please contact us at weclimbstronger@gmail.com
Limited Liability
We are not liable for the use or misuse of our products. Use of our products is entirely your responsibility and any claims against us or our products are limited to the cost of purchase.